Bootstrap
Welcome

Robot Butterfly Assembly - Chapter 10/14

Thread the cables through the slot in the lid.

 
67%

Thread the servo cables and Neopixel cable through the side slot on the Chonky circuit board.

 
68%

Connect the Neopixel cable to the 3 pin header (M) with the ‘Neopxl’ label. The dot is Gnd, followed by Vcc, and DIN. Refer to the note prior about colour labels.

 
70%

Connect the servo cables to the 3 pin header (M) with the corresponding label for left and right. The dot is Gnd which goes to black / brown.

 
71%

Pull the wires taut such that the excess wires is above the top side of Chonky for now.

 
72%

Page last updated: January 20 2025 07:46:53.